AUMA SAV 07.2 Operation Instructions Manual page 26

Electrical connection
Potential of customer
connections
26
SAV 07.2 SAV 16.2 / SARV 07.2
Table 9:
Protection on site
Multi-turn actu- 3-phase AC motor 380 V
ator
Consumed rated
power
P [kW]
Type
IN
SAV 07.2 0.6
SARV 07.2
0.6
0.8
SAV 07.6 0.9
SARV 07.6
1.2
1.3
SAV 10.2 1.3
SARV 10.2
1.8
2.0
SAV 14.2 1.7
SARV 14.2
3.1
3.9
SAV 14.6 2.9
SARV 14.6
5.0
6.2
SAV 16.2 5.3
SARV 16.2
1) For motor with different current type/mains voltage/mains frequency (refer to motor name plate),
select fuse in accordance with electrical data sheet.
2) The actuators are suitable for use in current circuits with a maximum short-circuit 1-phase AC current
value of 5,000 A root-mean-square (R.M.S). The output data of the fuses to be provided on site
must not exceed the following values: 32 A/600 V at a maximum mains mains short circuit current
of 5,000 A AC.
Consider the max. current (I
when selecting the circuit breaker.
We recommend refraining from using residual current devices (RCD). However, if
an RCD is used within the mains, the residual current device must be of type B. DC
current may be present within the PE conductor.
Implementation of overcurrent protection devices is not required. Actuator controls
are equipped with own protection mechanisms, adapted to the actuator system.
Therefore, we recommend refraining from using overcurrent protection devices.
For actuator controls equipped with a heating system and external electronics power
supply, the fuses for the heating system have to be provided by the customer (refer
to wiring diagram F4 ext.)
Table 10:
Fuse for heating system
Designation in wiring diagram = F4 ext.
External power supply
Fuse
If actuator controls are mounted separately from actuator ( actuator controls on wall
bracket): Consider length and cross section of connecting cable when defining the
protection required.
Refer to Technical data for options of isolated potentials.
SARV 16.2 Control unit: electronic (MWG)
480 V/50 Hz 60 Hz
Rated current Max. current
I [A] I
N max
1.3
1.4
1.7
2.0
2.6
3.0
2.8
4.0
4.5
3.8
6.8
8.7
6.5
11.1
13.7
10.9
) (refer to motor name plate or electrical data sheet)
max
115 V AC
2 A T
ACV 01.2 HART
1) 2)
Fuse
Blow characteristics:
Time-delay (gG)
[A]
[A]
1.8 6
2.5 6
3.5 6
2.8 6
4.3 6
4.8 6
4.4 6
6.9 10
7.4 10
6.1 10
11.0 16
15.2 20
9.9 16
17.9 20
22.6 25
17.2 20
230 V AC
1 A T