Hart Terminal Compartment: Open (Version With Hart Connection Board) - AUMA SAV 07.2 Operation Instructions Manual

SAV 07.2 SAV 16.2 / SARV 07.2
ACV 01.2 HART
6.2.4.

HART terminal compartment: open (version with HART connection board)

SARV 16.2 Control unit: electronic (MWG)
Figure 30: Open cover to HART terminal compartment
[1] Cover (HART terminal compartment)
[2] Screws for cover
[3] O-ring
[4] Cable entries for HART cables
[5] Blanking plug
Only for version with SD electrical connection, with HART connection board.
Electric shock due to presence of hazardous voltage!
Failure to observe this warning results in death or serious injury.
Disconnect device from the mains before opening.
Wait for 30 seconds after power cut-off prior to opening the housing.
Electrostatic discharge ESD!
Risk of damage to electronic components.
Earth both operators and devices.
1. Loosen screws [2] and remove cover [1].
2. Insert cable glands suitable for HART cables.
The enclosure protection IP... stated on the name plate is only ensured if suit-
able cable glands are used.
Figure 31: Example: Name plate for enclosure protection IP68
3. Seal unused cable entries with suitable plugs.
Electrical connection
33