AUMA SAV 07.2 Operation Instructions Manual page 3

SAV 07.2 SAV 16.2 / SARV 07.2
ACV 01.2 HART
6.2.5. HART cables: connect
6.2.6. HART terminal compartment: close (version with HART connection board)
6.3. Accessories for electrical connection
6.3.1. Actuator controls on wall bracket
6.3.2. Parking frame
6.3.3. DS intermediate frame for double sealing
6.3.4. External earth connection
7. Operation................................................................................................................................
7.1. Manual operation
7.1.1. Manual valve operation
7.2. Motor operation
7.2.1. Operating the actuator from local controls
7.2.2. Actuator operation from remote
7.3. Menu navigation via push buttons (for settings and indications)
7.3.1. Menu layout and navigation
7.4. User level, password
7.4.1. Password entry
7.4.2. Password change
7.4.3. Timeout for incorrect password entry
7.5. Language in the display
7.5.1. Language change
8. Indications..............................................................................................................................
8.1. Indications during commissioning
8.2. Indications in the display
8.2.1. Feedback signals from actuator and valve
8.2.2. Status indications according to AUMA classification
8.2.3. Status indications according to NAMUR recommendation
8.3. Indication lights of local controls
8.4. Optional indications
8.4.1. Mechanical position indication (self-adjusting)
8.4.2. Mechanical position indication via indicator mark (not self-adjusting)
9. Signals (output signals).........................................................................................................
9.1. Signals via HART
9.2. Status signals via output contacts (digital outputs)
9.2.1. Assignment of outputs
9.2.2. Coding the outputs
9.3. Analogue signals (analogue outputs)
10. Commissioning (basic settings)...........................................................................................
10.1. Type of seating: set
10.2. Torque switching: set
10.3. Limit switching: set
10.4. HART address (slave address): set
10.5. Output speed (internal): set
10.6. Test run
10.6.1. Direction of rotation at mechanical position indicator: check
10.6.2. Direction of rotation at hollow shaft/stem: check
10.6.3. Limit switching: check
SARV 16.2 Control unit: electronic (MWG)
Table of contents
34
36
37
37
38
38
39
40
40
40
41
41
42
42
43
44
45
45
46
46
46
48
48
48
49
51
52
54
55
55
55
56
56
56
56
56
56
57
57
58
60
62
62
64
64
66
66
3