Terminal Compartment (For Mains Connection): Close - AUMA SAV 07.2 Operation Instructions Manual

Electrical connection
6.2.3.

Terminal compartment (for mains connection): close

32
SAV 07.2 SAV 16.2 / SARV 07.2
Figure 29: Terminal compartment: close
[1A] Cover (version S)
[1B] Connection housing (SD version)
[2] Screws
[3] O-ring
[4] Screws for socket carrier
[5] Socket carrier
[6] Cable gland (not included in delivery)
[7] Blanking plug
Short-circuit due to pinching of cables!
Risk of electric shock and functional failures.
Carefully fit socket carrier to avoid pinching the cables.
1. Insert the socket carrier [5] into the cover [1A] or connection housing [1B] and
fasten with screws [4].
2. Clean sealing faces of cover [1A] or connection housing [1B] and housing.
3. Check whether O-ring [3] is in good condition, replace if damaged.
4. Apply a thin film of non-acidic grease (e.g. petroleum jelly) to the O-ring and
insert it correctly.
5. Fit cover [1A] or connection housing [1B] and fasten screws [2] evenly crosswise.
6. Fasten cable glands and blanking plugs applying the specified torque to ensure
the required enclosure protection.
SARV 16.2 Control unit: electronic (MWG)
ACV 01.2 HART