Table of Contents
Advertisement
SQVEx 05.2
Commissioning (settings in the actuator)
11.2.2.
Gear stage of the reduction gearing: test/set
11.3.
Mechanical position indication via indicator mark (not self-adjusting)
Setting elements
74
SQVEx 14.2/ SQRVEx 05.2
The test/setting is only required if the mechanical position indicator cannot be correctly
set or if another swing angle range is ordered subsequently, for example, 120° ±15°
instead of 90° ±15° (replacement by the AUMA Service only).
1.
Refer to table and check if swing angle corresponds to the setting of the reduc-
tion gearing (stages 1 9).
Table 25:
Actuator swing angle and suitable reduction gearing setting
SQV 05.2 / SQV 07.2
30° +/ 15°
2
60° +/ 15°
3
90° +/ 15°
3
120° +/ 15°
3
150° +/ 15°
4
180° +/ 15°
4
210° +/ 15°
4
290° +/ 70°
5
2.
To modify settings, lift the lever at the reduction gearing and engage at the se-
lected stage.
Figure 89: Set reduction gearing
Figure 90: Mechanical position indication via indicator mark
The mechanical position indicator shows the valve position via two indicator discs
with symbols
(OPEN) and
OPEN/CLOSED point to the indicator mark
The position indications is housed in the actuator switch compartment. The switch
compartment must be opened to perform any settings. Refer to <Switch compartment:
open/close>.
SQRVEx 14.2 Control unit: electronic (MWG)
SQV 10.2
SQV 12.2
2
3
3
4
3
4
4
5
4
5
4
5
5
6
5
6
(CLOSED). When correctly set, the symbols
at the cover in the end positions.
ACVExC 01.2 Modbus RTU
SQV 14.2
4
5
6
6
6
7
7
7
Advertisement
Table of Contents
