Terminal Compartment (For Mains Connection): Open - AUMA SAV 07.2 Operation Instructions Manual

SAV 07.2 SAV 16.2 / SARV 07.2
ACV 01.2 HART
6.2.1.

Terminal compartment (for mains connection): open

Information
SARV 16.2 Control unit: electronic (MWG)
Figure 26: Terminal compartment: open
[1A] S/SH cover (figure shows S version)
[1B] Connection housing (SD version)
[2] Screws
[3] O-ring
[4] Screws for socket carrier
[5] Socket carrier
[6] Cable entry
[7] Blanking plug
[8] Cable gland (not included in delivery)
For S/SH version, connection of HART cables is made at the socket carrier. For SD
version, connection of HART cables is separate of mains connection (refer to <HART
terminal compartment: open>).
Electric shock due to presence of hazardous voltage!
Failure to observe this warning results in death or serious injury.
Disconnect device from the mains before opening.
Wait for 30 seconds after power cut-off prior to opening the housing.
1. Loosen screws [2] and remove cover [1] or connection housing [1B].
2. Loosen screws [4] and remove socket carrier [5] from cover [1A] or connection
housing [1B].
Electrical connection
29