Mechanical Position Indicator (Self-Adjusting); Mechanical Position Indicator: Set - AUMA SAV 07.2 Operation Instructions Manual

SAV 07.2 SAV 16.2 / SARV 07.2
ACV 01.2 HART
11.2.

Mechanical position indicator (self-adjusting)

Information
11.2.1.

Mechanical position indicator: set

SARV 16.2 Control unit: electronic (MWG)
Figure 75: Mechanical position indicator (self-adjusting)
The self-adjusting mechanical position indicator shows the valve position by means
of an arrow . When correctly set, the arrow points to symbol
(CLOSED) in the end positions.
The position indications is housed in the actuator switch compartment. Opening the
switch compartment for manual setting is only necessary if the gear stage setting
must be modified of if the factory settings of predefined end position CLOSED (or
OPEN) must be adapted when commissioning.
1. Move valve to end position CLOSED.
2.
Push both lower discs with the symbols
each other. The disc with the arrow is thereby
Figure 76: Setting position in CLOSED
3. Move actuator to end position OPEN.
The arrow rotates in direction OPEN driving the indicator disc with symbol
(OPEN) until the actuator stops in position OPEN.
Figure 77: Operation in direction OPEN (left) and position OPEN (right)
Commissioning (settings/options in the actuator)
(OPEN) and
is driven:
(OPEN) or
(CLOSED) towards
69