Operation Check 2 - Mitsubishi Electric Fatec GOT2000 Series Basic Training Textbook

5.11 Operation check 2

Display the screen for writing a project, and then write data to the GOT.
Reset the PLC CPU using the RESET key switch, and then switch to RUN.
Check if the comment display in screen No. 1 is properly displayed, and that the overlap window (Window Screen No. 1)
appears correctly here.
(1) Test 1
Perform the following tests in screen No. 1.
Item
Touch operation
Screen status
Write device
(2) Test 2
Perform the following tests in screen No. 1.
Item
Touch operation
Screen status
Write device
Read device
(3) Test 3
Perform the following tests in screen No. 1.
Item
Touch operation
Screen status
Write device
Read device
5 - 70
5. Drawing fundamentals
5.11 Operation check 2
Test object
Touch the numerical input area.
When a key window screen appears, enter the numeric value (15), and then press
Enter of the key window.
D10
Test object
Line start switch
The switch is pressed.
Test object
Line stop switch
It is touched while the operation lamp is
The switch is pressed.
M10: OFF
Planned operating time (numerical input)
Touch
M10: ON
────
on.
────
Comment display
────
Comment "Line operating" appears.
────
Y7B: ON
Comment display
-
Comment "Line stopped" appears.
────
Y7B: OFF