Appendix.5 Installing The Coreos - Mitsubishi Electric Fatec GOT2000 Series Basic Training Textbook

Appendix.5 Installing the CoreOS

This section explains how to install the CoreOS to the GOT.
Use the data storage to install the CoreOS to the GOT.
P O I N T
P O I N
(1) Canceling writing the package data
When writing the package data is canceled during the process, the data in the GOT may be corrupt.
When writing the package data has been canceled during the process, write the package data again.
(2) Data in the GOT before the CoreOS is installed
When the CoreOS is installed, all the data in the GOT are deleted.
When the data in the GOT is required, read the data in advance.
(3) Precautions for installing the CoreOS
The data storage of when the CoreOS is installed supports only the drive A (standard SD card).
When the CoreOS is installed, all the data in the memory card are deleted.
(4) Precautions for the utilize data and the input assist information
When [Utilize data/Input assist information] is excluded from the package data at writing, the project read from
the GOT operates as follows.
• The accumulated input assist information return to the initial status.
• The project data is not searched for when a new project is to be created using another project.
(1) Writing the CoreOS to the data storage
(Next page)
1.
Click [Communication] - [Write to Memory Card]
from the menu.
2.
The Communicate with Memory Card dialog
appears. Click the [BootOS/CoreOS Write] tab.
2.
3.
Configure the following setting in [PC].
3.
Write Data: CoreOS
GOT Type: GT27**-S(800×600)
Check the CoreOS version to be installed in
4.
[Version].
4.
Set the drive name of the data storage for
5.
[Destination Memory Card].
5.
Click the button.
App - 39
1
2
3
4
5
6