Buffer - Elnec MEMprog2 User Manual

Buffer

Menu Buffer is used for buffer manipulation, block operation, filling a part of buffer with string,
erasing, checksum and of course editing and viewing with other items (find and replace
string, printing...).
Buffer / View/Edit
This command is used for view (view mode) or edit (edit mode) data in buffer (for viewing in
DUMP mode only). Use arrow keys for select the object for edit. Edited data are signified by
color.
You can use <F4> hot key also.
View/Edit Buffer
F1
F2
Ctrl+F2
Ctrl+Shift+F2
F3
F4
F5
F6
F7
F8
F9
F10
F11
F12
Arrow keys
Home/End
PgUp/PgDn
Ctrl+PgUp/PgDn jump on start / end current page
Ctrl+Home/End jump on start / end current device
Shift+Home/End jump on start / end current buffer
Backspace
Note: characters 20H - FFH (mode ASCII) and numbers 0..9, A..F (mode HEX) immediately
changes content of edit area.
display help of actual window
fill block causes filling selected block of buffer by requested hex (or ASCII)
string. Sets start and end block for filling and requested hex or ASCII string.
erase buffer with specified blank value
fill buffer with random data
copy block is used to copy specified block of data in current buffer on new
address. Target address needn't be out from source block addresses.
move block is used to move specified block of data in current buffer on new
address. Target address needn't be out from source block addresses.
Source address block (or part) will be filled by topical blank character.
swap bytes command swaps a high- and low- order of byte pairs in current
buffer block. This block must start on even address and must have an even
number of bytes. If these conditions do not fulfill, the program modifies
addresses itself (start address is moved on lower even address and/or end
address is moved on higher odd address).
print buffer
find string (max. length 16 ASCII characters)
find and replace string (max. 16 ASCII chars.)
change current address
change mode view / edit
switch the mode of buffer data view between 8 bit and 16 bit view. It can be
also doing by mouse clicking on the button to the right of View/Edit mode
buffer indicator. This button indicates actual data view mode (8 bit or 16
bit), too.
checksum dialog allows to count checksum of selected block of buffer
change mode view / edit
move cursor up, down, right and left
jump on start / end current line
jump on previous / next page
move cursor one position left (back)
99
Pg4uw