Elnec MEMprog2 User Manual page 156

programmer (site) with desired serial number. Programmers or Programmer Sites with
different serial numbers will be ignored. If the Pg4uwMC does not find desired Programmer
Site, the Programmer Site will be set to Demo mode with status set to "Not found".
On one computer, 8 Programmer Sites can be run at the same time.
Job Report settings are used to set mode of using Job Report.
Job Report represents the summary description of operation recently made on device. Job is
associated with project file and it means the operation starting with Load project until loading
of new project or closing program Pg4uwMC.
Job Report contains following information:
• project name
• project date
• Protected mode status
• Pg4uwMC software version
• programmer type and serial number
• start time of executing the Job (it means time when Load project operation was
performed)
• end time of executing the Job (time of creating the Job Report)
• device name
• device type
• checksum
• device operation options
• serialization information
• statistics information
Job Report is generated in following cases:
• user command Load project is selected
• closing or disconnecting programmer sites is selected
• closing the Pg4uwMC
• device Count down counter reaches 0 (finished status)
• manually by user, when menu "File | Job Report" is used
The Job Report is generated for recently loaded project file, only when statistics value of
Total is greater than 0.
It means, at least one device operation (program, verify,...) must be performed.
Job Report dialog settings are in dialog Pg4uwMC Settings (menu Options | Settings) in tab
Job Report.
Following options are available for Job Report:
156
ELNEC s. r. o.