Pg4Uw-The Programmer Software - Elnec MEMprog2 User Manual

Pg4uw-the programmer software

Program Pg4uw.exe is common control program for all ELNEC programmers. We guarantee
running of these programs under all of above mentioned operating systems without any
problems. Also background operation under Windows is error-free.
Using the programmer software
Run the control program
In Windows environment: double click to icon Pg4uw.
After start, control program Pg4uw automatically scan all existing ports and search for the
connected any ELNEC programmer. Program Pg4uw is common for all the ELNEC
programmers, hence program try to find all supported programmers.
Notes: When Pg4uw is started, program is checked for its integrity. Than the program display
a standard user menu and waits for your instructions.
If the control program cannot communicate with the programmer, an error message appears
on the screen, including error code and description of possible reasons (disconnected
programmer, bad connection, power supply failure, incompatible printer port...). Eliminate the
error source and press any key. If error condition still exists, the program resumes its
operation in the demo mode and access to the programmer is not possible. If you cannot find
the cause of the error, follow the instructions in Troubleshooting section. In addition, the
control program checks communication with programmer prior to any operation with the
programmed device.
The control program delivered by ELNEC, included on the
CD in your package, is granted to be free from any viruses
at the moment of delivery. To increase their safety our
programs include a special algorithm for detecting possible
virus infections.
90
ELNEC s. r. o.