Introduction - Elnec MEMprog2 User Manual

ELNEC s. r. o.

Introduction

BeeProg2 is a very fast universal USB/LPT interfaced universal programmer built to meet the
strong demand of the small manufacturing and developer's community for the fast and
reliable universal programmer.
BeeProg+ is a fast universal USB/LPT interfaced universal programmer built to meet the
strong demand of the small manufacturing and developer's community for the fast and
reliable universal programmer.
BeeProg2 / BeeProg+ support all kinds of types and silicon technologies of today and
tomorrow programmable devices without family-specific module. You have freedom to
choose the optimal device for your design. Using built-in in-circuit serial programming (ISP)
connector, the programmer is able to program ISP capable chips in circuit.
BeeProg2 / BeeProg+ aren't only programmer, but also tester of TTL/CMOS logic ICs and
memories. Furthermore, it allows generating user-definable test pattern sequences.
BeeProg2 / BeeProg+ provide very competitive price coupled with excellent hardware design
for reliable programming. It is probably best "value for money" programmer in this class.
BeeProg2 / BeeProg+ provide very fast programming due to high-speed FPGA driven
hardware and execution of time-critical routines inside of the programmer. It is at least fast
than competitors in this category, for many chips much faster than most competitors. As a
result, when used in production this one-socket-programmer waits for an operator, and not
the other way round.
BeeProg2 / BeeProg+ interfaces with the IBM PC Pentium compatible or higher, portable or
desktop personal computers through USB (2.0/1.1) port or any standard parallel (printer) port.
Programmer can utilize power of both USB high-speed port and IEEE1284 (ECP/EPP) high-
speed parallel port. Support of both USB/LPT port connections gives you the choice to
connect the BeeProg2 / BeeProg+ programmer to any PC, from latest notebook to older
desktop without USB port.
BeeProg2 / BeeProg+ provides a banana jack for ESD wrist straps connection to easy-to-
implement the ESD protection control and also other banana jack for earth wire.
BeeProg2 / BeeProg+ have a FPGA based totally reconfigurable 48 powerful TTL pindrivers,
where provide H/L/pull_up/pull_down and read capability for each pin of socket. Advanced
pindrivers incorporate high-quality high-speed circuitry to deliver signals without overshoot
or ground bounce for all supported devices. Improved pindrivers operate down to 1.8V so
you'll be ready to program the full range of today's advanced low-voltage devices.
BeeProg2 / BeeProg+ performs device insertion test (wrong or backward position) and
contact check (poor contact pin-to-socket) before it programs each device. These
capabilities, supported by overcurrent protection and signature-byte check help prevent
chip damage due to operator error.
The selftest capability allows running diagnostic part of software to thoroughly check the
health of the programmer.
30