Elnec BeeHive208S How-To Manual

Replacing the memory modules
Hide thumbs Also See for BeeHive208S:

Advertisement

Replacing the memory modules NVT-0573 in the BeeHive208S
Replacing the memory modules NVT-0573 in the
BeeHive208S
How-Do-It Manual
October 2018
BeeHive208S_replacing_NVT-0573_RAM,
version 1.00
Version 1.00/10.2018
page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BeeHive208S and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Elnec BeeHive208S

  • Page 1 Replacing the memory modules NVT-0573 in the BeeHive208S Replacing the memory modules NVT-0573 in the BeeHive208S How-Do-It Manual October 2018 BeeHive208S_replacing_NVT-0573_RAM, version 1.00 Version 1.00/10.2018 page 1...
  • Page 2: Required Tools

    Terms definition: Site - the site is a component of the BeeHive208S programming unit. Each the site has its own ZIF programming socket. The sites are independent each other. Motherboard - main board of the computer inside the BeeHive208S programmer.
  • Page 3 Replacing the memory modules NVT-0573 in the BeeHive208S Removing the upper cover of the programmer's unit  Remove the supply cable from the programmer's unit.  Place the programmer's unit on the bench in such a way that the connectors may point to you.
  • Page 4 If you cannot locate faulty memory slot, we recommend you trial-and-error method. Select memory module, replace one, power on the BeeHive208S programmer and check if faulty memory module was replaced. If so, switch off the programmer and assembly programmer by sequence described in following paragraph.
  • Page 5 Replacing the memory modules NVT-0573 in the BeeHive208S  Screw the screws on the front and top side of the upper cover.  Turn the programmer's unit so, that connector may point to you.  Screw the screws on the rear side of the programmer.

Table of Contents