Power Source; Switching The Power On; Switching The Power Off - Fuji Xerox DocuCentre S2010 User Manual

3 Product Overview

Power Source

Switching the Power On

The following describes how to switch the power on.
The machine takes approximately 30 seconds to warm up and to be ready to copy or
print after the power is turned on. It may take slightly longer than normal depending on
the device configuration.
Switch the power off at the end of the day or when not using the machine for an
extended period of time.
1
Press the power switch to the [ | ] position to
switch the power on.
3
Note

Switching the Power Off

Important • Do not switch the power off in the following situations. If the power is switched off, the
Note
1
Before switching the power off, make sure that the machine has completed all copy or
print jobs. Then, make sure that the <Data> indicator does not light up.
52
• While the machine is warming up, the status
machine diagram displays as shown in the
right image. The machine is not accessible
while it's warming up.
• Make sure that the power cable is
connected to the machine and the wall
outlet properly.
processing data may be erased.
While data is being received
While a job is being printed
While a job is being copied
While a job is being scanned
• When switching the power off, wait 5 seconds after outputs have been delivered.
• When powering the machine on after it has been switched off, wait 10 seconds after the
display goes off.