Figure 5-1 Locations of screws holding the cable support
2.
Lower the cable support.
5.5.2
Removing the power cord
When removing the power cord of the SPARC M10-4S or the crossbar box to perform
maintenance work on a component, do so only after removing the cable clamp from
the power cord.
1.
Release the latch (A in the figure) of the cable clamp.
Pulling the cable clamp toward the rear of the chassis facilitates release of the
latch.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ・ February 2014
66