Removing The Power Cord - Fujitsu M10-4 Service Manual

3.
Lower the cable support.
Figure 5-9 Handling the cable support
5.9.4

Removing the power cord

To perform work in cold maintenance, remove the power cord of the SPARC
M10-4/M10-4S. Remove the cable clamp from each power cord, and then remove the
power cords.
1.
Release the latch (A in the figure) of the cable clamp.
Figure 5-10 Removing the cable clamp
2.
Remove the power cord from the PSU backplane unit.
A
Chapter 5 Preparations Required for Maintenance 85