Fujitsu M10-4 Service Manual page 462

Figure 28-25 Installing the cable (cable (PWR))
C
B
■
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
438
For the cable (SIG), install the connector that has a threaded hole to the
terminal board.
Use the screw that was removed from the same location before. Tighten the
screw with a Phillips screwdriver (bit No. 1). When installing the connector,
orient the connector so that the dot mark (A in the figure) is on the left as
shown in Figure 28-26.
A