Installing A Crossbar Unit - Fujitsu M10-4 Service Manual

Figure 9-3 Opening the eject levers
3.
Support the crossbar unit from below with one hand and carefully remove it
from the mounting frame.
Note - Place the removed crossbar unit on a grounded antistatic ESD mat.
9.5

Installing a Crossbar Unit

This section describes the procedure for installing a crossbar unit.
Note - When mounting a crossbar unit, check the connectors on both of the chassis
and crossbar unit beforehand to confirm that no pin is bent and all the pins are neatly
arranged in lines. If a crossbar unit is mounted with a bent pin in a connector, the
chassis or crossbar unit may be damaged. Also, carefully proceed with the work to
prevent any pin from being bent.
A
Chapter 9 Maintaining the Crossbar Units 195