Fujitsu M10-4 Service Manual page 316

3.
Pull the operation panel forward to remove it.
Note - Place the removed operation panel on a grounded antistatic ESD mat.
15.5 Installing the Operation Panel
This section describes the procedure for installing the operation panel.
15.5.1 Installing the operation panel
1.
Set the BB-ID of the operation panel to the value prior to the start of
maintenance.
2.
Place the operation panel in the mounting position and then tighten one
screw.
15.5.2 Restoring the chassis
1.
Connect the cables to the operation panel.
2.
Reinstall the PSU backplane unit in its original position and then tighten the
two screws.
3.
Reinstall the fan shelf and then tighten the two screws in the fan slot.
4.
Reinstall the power supply unit in its original position.
For details, see
5.
Install all the fan units.
For details, see
Note - Reinstall the fan units in their original positions by referring to the notes you made
prior to the start of maintenance.
6.
Install the front cover.
For details, see
Note - Check that the front cover is firmly attached and secured.
7.
Insert the CPU memory unit into the chassis.
8.
Raise the right and left levers of the CPU memory unit and then tighten the
one screw.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
292
"10.5.1 Installing a power supply
"11.5.1 Installing a fan
"6.5.3 Installing the front
unit."
unit."
cover."