Fujitsu M10-4 Service Manual page 124

Figure 7-7 Fixing crossbar cables
2.
Lower the cable support.
For details, see
3.
Remove all the cables connected to the external interface on the rear of the
chassis.
The cables to be removed are as follows.
■
■
■
■
■
■
■
■
■
Note - Record the positions of the cables before removing them to ensure that they are
reinstalled correctly.
4.
Remove all the PCIe card cassettes.
For details, see
Note - Make a note of the positions of the PCIe card cassettes before removing them to ensure
that they are reinstalled correctly.
5.
If any crossbar units are mounted, remove them.
For details, see
6.
Loosen the three screws holding the mounting frame and then remove it.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
100
"5.5.1 Lowering the cable
Interface cable connected to the PCI Express (PCIe) card
Crossbar cables (They may have been removed in step 1.)
XSCF BB control cable
XSCF DUAL control cable
XSCF-LAN cable
Serial cable
LAN cable
SAS cable
USB cable
"13.5.2 Removing a PCI Express card
"9.4.2 Removing a crossbar
support."
cassette."
unit."