Fujitsu M10-4 Service Manual page 336

The cables to be reconnected are as follows.
■
■
■
Note - Reinstall the cables in their original positions by referring to the notes that you made
prior to the start of maintenance.
Note - After connecting the cables, use the hook-and-loop fastener to bundle and fix the
cables to the cable support at the rear.
17.6 Restoring the System
This section describes the procedure for restoring the system after installing the XSCF
unit. The restoration procedure differs depending on the maintenance type as follows:
Active/Hot maintenance
■
System-stopped maintenance
■
17.6.1 Active/Hot maintenance
1.
Check that the XSCF STANDBY LED on the operation panel is on.
For the location of LEDs, see
2.
Return to the operation of the XSCF firmware replacefru command to confirm
that the XSCF unit has been incorporated into the system.
For details, see
3.
Execute the switchscf command to switch the standby XSCF to the master
XSCF.
Execute the command if the chassis requiring maintenance has been switched to
the standby XSCF.
XSCF> switchscf -t Active
4.
Close the rack door.
17.6.2 System-stopped maintenance
1.
Connect all the power cords to the power supply unit of the crossbar box
requiring maintenance.
For details, see
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
312
Serial cable
LAN cable
USB device
"6.1.2 Incorporating an FRU of the crossbar box into the
"6.5.1 Installing the power
"2.3.3 LEDs on each component."
cord."
system."