Installing And Removing A Power Over Ethernet Module (Optional); Installing The Power Over Ethernet Module - Fujitsu FUTRO S930 Operating Manual

Installing and removing a Power over Ethernet
module (optional)
You can install an additional Power over Ethernet module in your device.
Before using the module for the first time, please observe the notes
in chapter
If you are supplying the system with power via the PoE module, ensure that
no additional power supply (mains adapter) is connected.

Installing the Power over Ethernet module

Power overEthernetmodule,
► Open the casing (see
► If a PCIe board is installed, you must remove the cross piece and PCIe
board (see "Removing the board", Page
► FUJITSU Desktop ESPRIMO A525-L: If a hard disk is installed, remove
it (see "Removing a hard disk", Page
► Break the cover (1) out of the casing.
► Place the Power over Ethernet module in the casing with the component side
facing upwards (2). Ensure that it engages in the slot.
Fujitsu
"Getting started", Page
"Opening the casing", Page
1
16.
34).
60).
44).
2
System expansions
55