Fujitsu M10-4 Service Manual page 460

Figure 28-23 Removing the cable (cable (SIG))
28.5 Installing the Cable Kit
This section describes the procedure for installing the cable kit at each cable
connection destination.
For the cable connection destinations, see
Install a cable that has the same shape as the removed cable.
28.5.1 Installing a cable between the crossbar backplane
unit and terminal board
Install the cable (SIG) or cable (PWR) connecting the crossbar backplane unit and
terminal board.
1.
Connect the cable to the connector of the crossbar backplane unit.
Install the cable that has the same shape as the removed cable.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
436
"28.1 Configuration of the Cable Kit."