Fujitsu M10-4 Service Manual page 300

Figure 14-6 Handle of PSU backplane unit
3.
Remove the operation panel.
For details, see step 2 and later in
14.5 Installing the PSU Backplane Unit
This section describes the procedure for installing the PSU backplane unit.
14.5.1 Installing the PSU backplane unit
1.
Install the operation panel on the PSU backplane unit.
For details, see
2.
Insert the PSU backplane unit into the chassis by holding the handle.
3.
Tighten the two screws securing the PSU backplane unit.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
276
"15.4.2 Removing the operation
"15.5.1 Installing the operation
panel."
panel."