Starting The System With An Xscf Command; Starting The System From The Operation Panel - Fujitsu M10-4 Service Manual

------------------------ Ommitted ------------------------
PCI#0 Status:Normal; Name_Property:pci;
+ Vendor-ID:108e; Device-ID:9020;
+ Subsystem_Vendor-ID:0000; Subsystem-ID:0000;
+ Model:;
+ Connection:7001;
PCIBOX#7001; Status:Normal; Ver:1110h; Serial:2121237001;
+ FRU-Part-Number:;
IOB Status:Normal; Serial:PP123403JE ;
+ FRU-Part-Number:CA20365-B66X 008AG ;
LINKBOARD Status:Normal; Serial:PP1234026P ;
+ FRU-Part-Number:CA20365-B60X 001AA ;
PCI#1 Name_Property:ethernet;
+ Vendor-ID:1077; Device-ID:8000;
+ Subsystem_Vendor-ID:1077; Subsystem-ID:017e;
+ Model:;
------------------------ Ommitted -----------------------
For details, see
6.
Start the entire system.
For details, see
Starting the system from the operation
After a short while, the following processes are performed.
■
■
Then, the system starts up. For details, see "6.1 Starting the System" in the
Fujitsu M10/SPARC M10 Systems System Operation and Administration Guide.
6.4.1

Starting the system with an XSCF command

1.
Execute the poweron command.
In response to the confirmation message, enter "y".
XSCF> poweron -a
PPAR-IDs to power on:00,01
Continue? [y|n] : y
00 : Powering on
01 : Powering on
6.4.2

Starting the system from the operation panel

1.
Press the power switch on the operation panel for 1 second or more (less
"3.3.3 Checking the status of a
"6.4.1 Starting the system with an XSCF
The POWER LED on the operation panel will be turned on.
The power-on self-test (POST; self diagnosis when powering on) will be
executed.
Chapter 6 Understanding the Preparations for Restoring the System
component."
command" or
panel."
"6.4.2
79