Fujitsu M10-4 Service Manual page 411

Enable the removal of the crossbar cables (optical) before attempting to remove them.
For details, see "25.3 Enabling the Removal of a Crossbar Cable
Caution - Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see
Regarding Static Electricity."
1.
Remove the two crossbar cables (optical) from the SPARC M10-4S.
Remove the crossbar cable (optical) by holding the tab (A in the figure) of the
cable and pulling it straight in the direction of the arrow. At this time, do not
hold the cable part when pulling the crossbar cable. Pulling the cable part
without the connector lock completely released may cause damage.
Figure 25-5 Removing the crossbar cables (optical) (SPARC M10-4S)
2.
Remove the other pair of crossbar cables (optical) from the crossbar box.
Remove the crossbar cable (optical) by holding the tab (A in the figure) of the
cable and pulling it straight in the direction of the arrow. At this time, do not
hold the cable part when pulling the crossbar cable. Pulling the cable part
without the connector lock completely released may cause damage.
Chapter 25 Maintaining the Crossbar Cables (Optical)
(Optical)."
"1.5 Notes
387