Table 9-1 Types of maintenance for the crossbar unit
Configuration
Building block configuration Unsupported
9.2.2
Maintenance flow
Table 9-2
Table 9-2 Maintenance flow
Details of update process
1
2
3
4
9.3
Enabling the Removal of a Crossbar
Unit
This section describes preparation that must be completed prior to removing a
crossbar unit. The procedure for the preparation varies depending on the maintenance
type, as follows:
Inactive/Cold maintenance
■
System-stopped maintenance
■
Caution - To completely shut down the system, all the power cords must be
removed. If the power cords are not removed, an electrical failure may occur.
9.3.1
Inactive/Cold maintenance
1.
Open the rack door.
2.
Log in to the XSCF shell.
3.
Execute the showlogs command to identify the component requiring
maintenance.
Active/hot
Active/cold
Unsupported
lists the sequence of the maintenance procedure for the crossbar units.
Preparation
Removing the crossbar units
Installing the crossbar unit
Restoring the system
Inactive/hot
Inactive/cold
Unsupported
Supported
Chapter 9 Maintaining the Crossbar Units
System stopped
Supported
Replacement
9.3
9.4
9.5
9.6
191