Figure 12-3 Removing an internal disk
3.
Carefully remove the internal disk from its slot.
Note - Place the removed internal disk on the grounded antistatic ESD mat.
4.
When reducing an internal disk, install the the internal disk filler unit in the
slot from which the disk was removed.
12.5
Installing an Internal Disk
This section describes the procedure for installing an internal disk. Perform
expansion using the same procedure.
12.5.1
Installing an internal disk
1.
When expanding an internal disk, remove the internal disk filler unit from the
slot in which the disk is to be installed.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ・ February 2014
236