Installing And Removing A Power Over Ethernet Module (Optional); Installing The Power Over Ethernet Module - Fujitsu FUTRO S940 Operating Manual

System expansions
Installing and removing a Power over Ethernet
module (optional)
You can install an additional Power over Ethernet module in your device.
Before using the module for the first time, please observe the notes
in chapter
If you are supplying the system with power via the PoE module, ensure that
no additional power supply (mains adapter) is connected.

Installing the Power over Ethernet module

Power overEthernetmodule,
► Open the casing (see
► If a PCIe board or power supply is installed, remove the cross piece and PCIe board or power
supply (see "Removing the board", Page 47/"Remove power supply", Page
► Break the cover (1) out of the casing.
► Place the Power over Ethernet module in the casing with the component side
facing upwards (2). Ensure that it engages in the slot.
42
"Getting started", Page
"Opening the casing", Page
1
14.
31).
2
50).
Fujitsu