Fujitsu M10-4 Service Manual page 400

24.4 Removing a Crossbar Cable
(Electrical)
This section describes the procedure for removing the crossbar cables (electrical).
Enable the removal of the crossbar cables (electrical) before attempting to remove
them. For details, see
Caution - Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see
Regarding Static
1.
Remove the two crossbar cables (electrical) from the SPARC M10-4S.
Remove the crossbar cable (electrical) by holding the tab (A in the figure) of the
cable and pulling it straight in the direction of the arrow. At this time, do not
hold the cable part when pulling the crossbar cable. Pulling the cable part
without the connector lock completely released may cause damage.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
376
"24.3 Enabling the Removal of a Crossbar Cable
Electricity."
(Electrical)."
"1.5 Notes