Execute Was Auto-Calibration From The Plus+1 Service Tool - Danfoss PVED-CLS User Manual

ENGINEERING TOMORROW
During stage 2 the set point value will be increased or decreased respectively by 1 [10um] in the same manner as
during stage 1 until a successful spool dead-band calibration has been achieved.
9.4

EXECUTE WAS AUTO-CALIBRATION FROM THE PLUS+1 SERVICE TOOL

Open the PLUS+1 service tool and execute the matching .P1D.-file (SW in PVED-CLS needs to match the pages in the
.P1D-file).
 
-
Figure 23