Danfoss PVED-CLS User Manual page 23

ENGINEERING TOMORROW
1. Setup parameters in Hydraulic Config, Peripherals Config, SEHS Protocol Config and Vehicle Geometry
2. Do WAS auto calibration and manual spool calibration (direct output control), and setup parameters in Valve
Calibration Data, CAN WAS Calibration Data/Analogue WAS Calibration Data and Production/Calibration Flag
3. Setup parameters for steering device programs; GPS Config, STW Config and AUX Config
4. Setup parameters for SEHS FDA and Internal monitoring
5. Define parameters for Auto Calibration Config
6. Test Automatic spool calibration and verify safety setup of vehicle
For learning more of how the PLUS+1 SERVICE TOOL works, please go to the Danfoss Power Solution home page.
For using other tools than PLUS+1 SERVICE TOOL to manually changing parameters and updating sector- and
example in paragraph 16.4.5.
o the Danfoss document: PVED-CLS KWP2000 Protocol. Please see