Drive Clutch Removal - Club Car Precedent Maintenance And Service Manual
Electric vehicle with eric charging system gasoline vehicle with kohler ech440 engine
Hide thumbs
Also See for Precedent:
- Owner's manual (88 pages) ,
- Owner's manual (48 pages) ,
- Owner's manual (80 pages)
Table of Contents
Advertisement
GASOLINE VEHICLE - CLUTCHES
CAUTION
• Be very careful when handling the clutches. A clutch that has been dropped will not be properly
balanced. If either clutch is dropped, assume that it is damaged and replace it.
DRIVE CLUTCH REMOVAL
1.
Remove the drive belt as instructed. See Drive Belt Removal on page 23-3.
2.
Loosen starter/generator mounting and adjusting hardware and remove starter belt. See WARNING "Moving
parts! Do not..." in .
2962
Figure 23-3 Loosen Retaining Bolt
3.
Place chocks at the front wheels and lift the rear of the vehicle with a chain hoist or floor jack. Place jack stands
under the chassis to support the vehicle. The weight of the powertrain will allow the centerline of the drive clutch
to drop below the frame I-beam for access to the bolt securing the drive clutch. See following WARNING.
WARNING
• Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic floor
jack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold vehicle in raised
WARNING CONTINUED ON NEXT PAGE
596
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
Figure 23-4 Drive Clutch Removal
23
Drive Clutch
Page 23-5
Advertisement
Table of Contents
Troubleshooting
