Commutator Cleaning And Inspection - Club Car Precedent Maintenance And Service Manual

Electric vehicle with eric charging system gasoline vehicle with kohler ech440 engine

Hide thumbs Also See for Precedent:

Table of Contents

Starter/Generator

COMMUTATOR CLEANING AND INSPECTION

Clean the carbon dust, dirt and oil from the commutator. Visually inspect the commutator for worn, burned or

glazed areas. Check for loose or raised commutator bars. Slight roughness of the commutator can be polished

away with 400 grit (or finer) sandpaper. See following CAUTION.

• Do not use emery cloth on the commutator. Particles of emery are conductive and may short-circuit

the commutator bars. Do not use oil or lubricants on the commutator or brushes.

Using a micrometer, measure the outside diameter at two points along the commutator. If the commutator outside

diameter is less than 1.535 inches (39 mm), replace the armature and bearings (Figure 19-10, Page 19-11).

2020 Precedent,Villager 2 and 4 Maintenance and Service Manual

Figure 19-9 Field Coil Assembly

GASOLINE VEHICLE - ELECTRICAL

Villager 2 Villager 4