Club Car Precedent Maintenance And Service Manual page 123

WHEEL BRAKE ASSEMBLIES
3. Insert the rear cable housing into the shock mount bracket (3) (Figure 6-31). Push the cable housing end into the
bracket to ensure the clips on the housing end secure the cable in position.
4. At the rear wheel brake, connect the cable to the brake actuator arm using new clevis pin (4) and new bow
tie locking pin (5).
651B
Figure 6-31 Connect Cables at Rear Brakes
5. Place the tab (6) on cable housing over the forward leaf spring mounting bolt (7) (Figure 6-32).
652B
Figure 6-32 Brake Cable Mounting Tab
6. Install the nut (8). Tighten the nut to 18.4 lb·ft (25 N·m).
7. Adjust the brake cable equalizer.
8. Electric Vehicle: Connect the batteries.
Gasoline Vehicle: Connect the battery and spark plug wire.
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
6
Brake Cable
Page 6-21