Brake Light Relay Installation; Fuel Gauge/Hour Meter; General Information - Club Car Precedent Maintenance And Service Manual
Electric vehicle with eric charging system gasoline vehicle with kohler ech440 engine
Hide thumbs
Also See for Precedent:
- Owner's manual (88 pages) ,
- Owner's manual (48 pages) ,
- Owner's manual (80 pages)
Table of Contents
Advertisement
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
4.
Remove the screws (2).
5.
Remove the brake light relay.
BRAKE LIGHT RELAY INSTALLATION
1.
Install the brake light relay (1) on the instrument panel (Figure 19-31, Page 19-28).
2.
Install the screws (2).
3.
Connect the wires to the brake light relay terminals (Figure 19-32, Page 19-29).
Pin Description
1
2
4
6
Figure 19-32 Brake Light Relay Terminals
4.
Install the instrument panel.
5.
Connect the battery and spark plug wire.
FUEL GAUGE/HOUR METER
GENERAL INFORMATION
With the key switch in the OFF position, the fuel gauge field is blank; however, the hour meter field is always ON.
When the key switch is turned to ON, the fuel gauge field activates. The fuel gauge initially registers full before
indicating the actual fuel level.
The hour meter displays the number of hours of use in increments of 0.1 (one tenth) hour, but does not record
additional time unless the key switch is in the ON position and the engine is on. When recording, the hourglass icon
on the left blinks.
Wire Color
Blue
Red
Black
Green
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
Fuel Gauge/Hour Meter
Page 19-29
19
Advertisement
Table of Contents
Troubleshooting
