Ac Power Connection - Club Car Precedent Maintenance And Service Manual

Electric vehicle with eric charging system gasoline vehicle with kohler ech440 engine
Hide thumbs Also See for Precedent:
Table of Contents

Advertisement

15

AC Power Connection

2
1. AC Cord 2. Wire Tie
2758
AC POWER CONNECTION
WARNING
• Install surge arrestors on incoming AC power lines. Surge arrestors will help protect electrical
components in the charger and on the vehicle from all but direct or close lightning strikes.
• Two high-frequency chargers can share a circuit, which should be a dedicated 15 or 20 ampere
separately protected (circuit breaker or fuse) single-phase branch circuit that complies with all
applicable electrical codes for the location.
• Connect the charger AC supply cord to a properly grounded, three-wire outlet within the voltage and
frequency range shown on the charger.
• Do not use an adapter to plug the charger with a three-prong plug into a two-prong outlet. Improper
connection of the equipment-grounding conductor can result in a fire or an electrical shock.
• Place all cords so they will not be stepped on, tripped over, or otherwise subjected to damage or stress.
NOTE: Make sure that the AC cord provided with your charger has the proper AC plug for your location. If it does not,
contact your Club Car representative to obtain the proper cord or plug.
Page 15-8
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
1
Figure 15-5 AC Cord Drip-Loop Example
ELECTRIC VEHICLE - BATTERY CHARGER

Advertisement

Table of Contents
loading

This manual is also suitable for:

Villager 2Villager 4

Table of Contents