Axle Shaft Oil Seal Installation - Club Car Precedent Maintenance And Service Manual

24
Axle Tubes, Axle Shafts and Wheel Bearings
2. Remove axle tube (2) from gearcase (4) (Figure 24-5, Page 24-6). See Axle Tube and Axle Shaft Removal on
page 24-6.
3. Pull oil seal (7) from gearcase (4).

AXLE SHAFT OIL SEAL INSTALLATION

1. Clean bore in gearcase (4) where new oil seal (7) will sit (Figure 24-5, Page 24-6).
2. Using an appropriate sized seal driver, drive in new oil seal (7) until 0.0393 in. (1 mm) below surface, not
fully seated.
3. Clean end of axle shaft (3) and carefully install axle tube (2) to avoid damaging new oil seal (7) with splines of
axle shaft. See Axle Tube and Axle Shaft Installation on page 24-7.
4. Refill transaxle with appropriate type and volume of oil. See Oil Change – Transaxle on page 24-2.
Page 24-8 2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
GASOLINE VEHICLE - TRANSAXLE