Electronics Module; Electronics Module Removal - Club Car Precedent Maintenance And Service Manual

13

Electronics Module

ELECTRONICS MODULE
See General Warnings on page 1-2.
While it is not necessary to remove the electronics module from the vehicle, access to individual components may be
easier with the module removed.

ELECTRONICS MODULE REMOVAL

1. Disconnect the batteries and discharge the controller (1). See Disconnect the Batteries – Electric Vehicles
on page 1-4.
2. Remove the batteries from the vehicle to provide enough room to access the controller (1) (Figure 13-11, Page
13-11). See Battery Replacement on page 14-5.
3. Remove the bolt (2) that secures the electronics module (3) to the battery bucket.
4. Pull electronics module (3) forward and disconnect the heavy gauge wires from the controller (1) and solenoid (4).
5. Disconnect the 16-pin connector, 4-pin connector, and spade connectors from the controller (1).
6. Disconnect the spade connectors on the front of the solenoid (4).
7. Disconnect the two wires from Tow/Run switch (5).
8. Lift the electronics module (3) from the vehicle. See following WARNING.
WARNING
• Shorting of battery terminals can cause personal injury or death.
– Do not place component mounting plate directly on top of batteries when removing or installing
plate.
– Remove plate from vehicle completely.
Page 13-10 2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
ELECTRIC VEHICLE - ELECTRICAL
COMPONENTS