Club Car Precedent Maintenance And Service Manual page 293

ELECTRIC VEHICLE - BATTERY CHARGER
ONBOARD CHARGER FAULT CODES
E-0-0-7
E-0-0-8
E-0-1-2
E-0-1-3
E-0-2-3
E-0-2-5
E-0-2-4
E-0-1-1
E-0-2-9
E-0-3-0
E-0-3-2
E-0-3-8
E-0-1-6
E-0-1-8
E-0-1-9
E-0-2-6
E-0-2-0
E-0-2-8
TABLE CONTINUED ON NEXT PAGE
Battery amp hour limit reached
Battery temperature is out of range
Reverse polarity error
Battery does not take current
AC voltage out of range
Charger failed to initialize
Charger is disabled by external comman (CANbus)
Software error
Algorithm error
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
Charger Troubleshooting
Possible causes: Poor battery health, discharged
battery, battery not connected correctly, and/or high
parasitic loads on the battery while it is charging.
• Replace the battery pack.
• Check the DC connections.
• Disconnect the parasitic loads.
• This error will automatically clear once the
charger is reset by cycling DC.
Possible battery temperature sensor error.
• Check the temperature sensor and connections.
• Reset the charger.
• This error will automatically clear once the condi-
tion has been corrected.
The battery is not connected to the charger correctly.
• Check the battery connections.
• This error will automatically clear once the condi-
tion has been corrected.
Battery voltage is detected but the charger is unable
to charge the battery. This can be due to an electrical
device connected between the charger and the bat-
tery, which passes through voltage but not current.
Make sure that the vehicle has original factory set
up.
AC voltage is out of range.
• Connect the charger to an AC source that pro-
vides stable AC between 85 - 270 VAC / 45 - 65
Hz.
• This error will automatically clear once the condi-
tion has been corrected.
The charger has failed to turn on correctly.
• Disconnect the AC input and battery for 30 sec-
onds. Connect the AC input and battery.
Charger has been disabled by an external controller
over the CANbus network. Contact OEM for instruc-
tion.
Software upgrade failure or script operation failure.
• Make sure the USB flash drive is properly for-
matted. Reconnect the USB flash drive to the
charger.
The selected charging profile is incompatible with the
charger software.
• Update the charger software or select a different
charging profile.
• Make sure that the default algorithm is selected.
15
Page 15-19