Kick Plate And Charger Receptacle Bezel Installation - Club Car Precedent Maintenance And Service Manual
Electric vehicle with eric charging system gasoline vehicle with kohler ech440 engine
Hide thumbs
Also See for Precedent:
- Owner's manual (88 pages) ,
- Owner's manual (80 pages) ,
- Owner's manual (48 pages)
Table of Contents
Advertisement
BODY AND TRIM
5.
Raise the forward portion of the rear beauty panel to disengage it from the tabs on the upper portion of the kick
plate.
6.
Remove the kick plate from vehicle.
KICK PLATE AND CHARGER RECEPTACLE BEZEL INSTALLATION
1.
Install the kick plate (3).
2.
Make sure that the front lower edge of the rear beauty panel mates with the kick plate.
3.
Install the three screws (1) and washers (2). Tighten the screws to 3.3 lb·ft (4.5 N·m).
4.
Install the two front screws (5). Tighten screws to 3.7 lb·ft (5 N·m).
5.
Install the floor mat.
6.
Install the charger receptacle bezel (4).
Figure 4-10 Kick Plate and Charger Receptacle Bezel Installation
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
Kick Plate and Charger Receptacle Bezel
– Electric Vehicles
4
Page 4-15
Advertisement
Table of Contents
Troubleshooting
