Club Car Precedent Maintenance And Service Manual page 211

CONTROLLER DIAGNOSTIC TOOL (CDT)
4.3.1. Disconnect the square four-pin connector (3) from the controller.
4.3.2. Connect the handset cord to the handset.
4.3.3. Connect the other end of the handset cord (without the adapter) (4) to the four-pin connector of
the controller (2) (Figure 11-4, Page 11-29).
4.3.4. Connect the vehicle batteries, positive (+) cable first.
4.3.5. If the handset functions when connected directly to the controller, the adapter plug or vehicle wire
harness should be thoroughly tested. See Test Procedure 2 – Handset Cord Adaptor on page
11-27. Section 12 — Electric Vehicle - Troubleshooting and Electrical System
4.4. Replace electronics module cover. See Speed Controller Installation, Section 13, Page 13-12.
701
Figure 11-4 CDT Connector On Controller
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
11
Connection Tests
Page 11-29