Brake Cluster Installation - Club Car Precedent Maintenance And Service Manual

WHEEL BRAKE ASSEMBLIES
16. Remove the clevis pin (10) from brake cable.
17. Remove and discard the bolts (11) and lock nuts (12).
18. Remove the brake back plate (13).

BRAKE CLUSTER INSTALLATION

CAUTION
• Before installing axle shaft, clean any residual oil from the exposed end of the axle tube and from
the oil seal area.
1. Install the brake back plate (1) onto the transaxle (Figure 6-23).
2731D
Figure 6-23 Brake Cluster Installation
2. Install new bolts (2) and lock nuts (3). Tighten the bolt heads to 30 lb·ft (40.6 N·m).
3. Install the clevis pin (4).
4. Install the new bow tie locking pin (5).
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
6
Brake Cluster
Page 6-15