Armature Ground Test - Club Car Precedent Maintenance And Service Manual

GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
1. Measure each position in two places, 90 degrees apart
496

ARMATURE GROUND TEST

CAUTION
• Do not submerge armature in solvent.
NOTE: Before testing, wipe the armature with a clean cloth and remove carbon dust and metal particles from between
commutator bars.
Using a multimeter set on 200 ohms, place the positive (+) probe on the commutator bars and the negative (–) probe
on the armature core. The reading should be no continuity. If the reading is incorrect, replace the armature and the
two bearings (Figure 19-11, Page 19-12).
1
1
A
2
A
Figure 19-10 Inspect Commutator
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
1
A 1
A
1
1
B B
19
Starter/Generator
Page 19-11