Disassembly Of The Starter/Generator To Service The Brushes; Brush Inspection And Replacement - Club Car Precedent Maintenance And Service Manual

GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
4. Loosen the pivot nuts (7) and bolts (5) (Figure 19-13, Page 19-15).
5. Remove the adjustment nut (4), washer (6) and adjustment bolt (1) (Figure 19-13, Page 19-15). Lower the
starter/generator and remove the belt (2) from the pulley.
6. Support the starter/generator so that when the pivot bolts (5) are removed the starter/generator will not fall.
Remove the two pivot nuts (7) and bolts (5) from the mounting bracket.
7. Remove the starter/generator.

DISASSEMBLY OF THE STARTER/GENERATOR TO SERVICE THE BRUSHES

1. Remove the two bolts (20) and pull commutator end cover (23) free of starter/generator housing (24) (Figure
19-1, Page 19-5). See following NOTE.
NOTE: If the brushes are not removed, contact between the brushes and commutator as the commutator end cover is
being removed or installed could damage the brushes. Lift the brush springs out of the notches in the brushes
and pull the brushes back from the center of the commutator end cover. The springs will rest on the sides of
the brushes and help prevent them from sliding towards the center of the cover (Figure 19-5, Page 19-7).
2. Remove brush covers (29 and 30), terminal hardware (25), brush springs (28), and brushes (27) (Figure 19-2,
Page 19-5). See following NOTE.
NOTE: To clean and inspect the armature/commutator and the bearings, see Disassembly of the Starter/Generator
to Service the Armature/Commutator on page 19-7.
20
487
Figure 19-1 Commutator End Cover

BRUSH INSPECTION AND REPLACEMENT

1. Visually inspect brushes. Replace brushes that are cracked or severely chipped.
2. Measure the length of each brush. Replace the brush set if a brush is less than 0.375 inch (9.5 mm) (Figure
19-3, Page 19-6).
23
24
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
Starter/Generator
29
30
Figure 19-2 Brush Covers and Brushes
19
23
Page 19-5