Table of Contents
Advertisement
19
Starter/Generator
1. Measure each position in two places, 90 degrees apart
496
ARMATURE GROUND TEST
CAUTION
• Do not submerge armature in solvent.
NOTE: Before testing, wipe the armature with a clean cloth and remove carbon dust and metal particles from between
commutator bars.
Using a multimeter set on 200 ohms, place the positive (+) probe on the commutator bars and the negative (–) probe
on the armature core. The reading should be no continuity. If the reading is incorrect, replace the armature and the
two bearings (Figure 19-11, Page 19-9).
Page 19-8
2018 Onward Maintenance and Service Manual
1
1
A
2
A
Figure 19-10 Inspect Commutator
ELECTRICAL COMPONENTS – SUBARU EX40
1
A
1
A
1
1
B
B
Advertisement
Table of Contents
Troubleshooting
