Armature Ground Test - Club Car Carryall 300 2018 Maintenance And Service Manual

20
Starter/Generator
1. Measure each position in two places, 90 degrees apart
496

ARMATURE GROUND TEST

CAUTION
• Do not submerge armature in solvent.
NOTE: Before testing, wipe the armature with a clean cloth and remove carbon dust and metal particles from between
commutator bars.
Using a multimeter set on 200 ohms, place the positive (+) probe on the commutator bars and the negative (–) probe
on the armature core. The reading should be no continuity. If the reading is incorrect, replace the armature and the
two bearings (Figure 20-11, Page 20-9).
Page 20-8 2018 Carryall 300 Maintenance and Service Manual
1
1
A
2
A
Figure 20-10 Inspect Commutator
ELECTRICAL COMPONENTS: PEDAL-START
1
A 1
A
1
1
B B
GAS VEHICLE