Industry Compliance; Setup; Rack Mounting - Crestron CNX-DVP4 Operation Manual

Digital Video Processor

Setup

12 • Digital Video Processor: CNX-DVP4

Industry Compliance

As of the date of manufacture, the CNX-DVP4 have been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling (N11785).
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: Some of the following subsections use the Crestron Viewport. Refer to the
latest revision of 2-Series Console Commands (Doc. 6002) for console command
details.

Rack Mounting

WARNING: To prevent bodily injury when mounting or servicing this unit in a
rack, take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
•
The unit should be mounted at the bottom of the rack if it is the only unit in
the rack.
•
When mounting this unit in a partially filled rack, load the rack from the
bottom to the top with the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
NOTE: If rack mounting is not required, rubber feet are provided for tabletop
mounting or stacking. Apply the feet near the corner edges on the underside of the
unit.
NOTE: Reliable earthing (grounding) of rack-mounted equipment should be
maintained. Particular attention should be given to supply connections other than
direct connections to the branch circuit. (e.g., use of power strips).
Two "ears" are provided with the CNX-DVP4 so that the unit can be rack mounted.
These ears must be installed prior to mounting. Complete the following procedure to
attach ears to the unit. A #2 Phillips screwdriver is required.
1. Using a #2 Phillips screwdriver, remove the three screws closest to the front
panel from one side of the unit.
Crestron CNX-DVP4
Operations Guide – DOC. 8170A