Logic Configuration; Logic Description - GE Multilin MIWII Instruction Manual

7 LOGIC CONFIGURATION

7 LOGIC CONFIGURATION 7.1LOGIC DESCRIPTION
MIWII incorporates 4 logic diagrams that can be configured independently using the ENERVISTA MII SETUP software
(Setpoint> Logic Configuration).
The default logic configuration is the following:
LOGIC
1
2
3
4
We can configure up to eight signals in the same Logic box with the following structure:
Each signal has the same configuration structure as the signals in outputs/LEDs.
To configure a logic box, we can proceed in the same way as for the outputs/LEDs configuration per signal. If we want to
assign more than one function to each signal, they must be all in the same group. We must click on the OR button, next
on I/O CONFIGURATION, and then select the desired group, etc.
There are two timers, pickup and dropout timers, which can be assigned to each logic box.
Signals must be used in order, starting with L1 IN1. If we want to use more than one signal in the same AND
gate, use L1 IN2 first and then L1 IN3. If we want to use another AND gate, use AND 2 first, and then AND3.
GEK-113308
I/O CONFIGURATION
No Definition
No Definition
No Definition
No Definition
IMPORTANT NOTE
MIWII Directional Power Protection System

7.1 LOGIC DESCRIPTION

PICKUP TIME DROPOUT TIME
0 0
0 0
0 0
0 0
7
7-1